How to Install and Uninstall cura1-lulzbot Package on openSUSE Leap

Last updated: November 23,2024

Deprecated! Installation of this package may no longer be supported.

1. Install "cura1-lulzbot" package

This is a short guide on how to install cura1-lulzbot on openSUSE Leap


    
        
            $
        

        
            
                sudo zypper refresh
            
                    
    
    Copied


    
        
            $
        

        
            
                sudo zypper install
            
                        
                cura1-lulzbot
            
                    
    
    Copied

2. Uninstall "cura1-lulzbot" package

This is a short guide on how to uninstall cura1-lulzbot on openSUSE Leap:


    
        
            $
        

        
            
                sudo zypper remove
            
                        
                cura1-lulzbot
            
                    
    
    Copied

3. Information about the cura1-lulzbot package on openSUSE Leap

Information for package cura1-lulzbot:
--------------------------------------
Repository : Main Repository
Name : cura1-lulzbot
Version : 21.06-bp153.1.16
Arch : x86_64
Vendor : openSUSE
Installed Size : 27,8 MiB
Installed : No
Status : not installed
Source package : cura1-lulzbot-21.06-bp153.1.16.src
Summary : 3D printing software aimed at RepRaps, Ultimaker and LulzBot
Description :
Cura is a software solution for 3D printing, aimed at RepRaps,
the Ultimaker and LulzBot. This package comes with its own version of CuraEngine.
This is the fork from AlephObjects to support also LulzBot printers.