How to Install and Uninstall perl-Test-NoWarnings Package on openSUSE Leap

Last updated: December 24,2024

1. Install "perl-Test-NoWarnings" package

Please follow the guidelines below to install perl-Test-NoWarnings on openSUSE Leap


    
        
            $
        

        
            
                sudo zypper refresh
            
                    
    
    Copied


    
        
            $
        

        
            
                sudo zypper install
            
                        
                perl-Test-NoWarnings
            
                    
    
    Copied

2. Uninstall "perl-Test-NoWarnings" package

Please follow the steps below to uninstall perl-Test-NoWarnings on openSUSE Leap:


    
        
            $
        

        
            
                sudo zypper remove
            
                        
                perl-Test-NoWarnings
            
                    
    
    Copied

3. Information about the perl-Test-NoWarnings package on openSUSE Leap

Information for package perl-Test-NoWarnings:
---------------------------------------------
Repository : Main Repository
Name : perl-Test-NoWarnings
Version : 1.04-1.25
Arch : noarch
Vendor : SUSE LLC
Installed Size : 46.2 KiB
Installed : No
Status : not installed
Source package : perl-Test-NoWarnings-1.04-1.25.src
Upstream URL : http://search.cpan.org/dist/Test-NoWarnings/
Summary : Make sure you didn't emit any warnings while testing
Description :
In general, your tests shouldn't produce warnings. This modules causes any
warnings to be captured and stored. It automatically adds an extra test
that will run when your script ends to check that there were no warnings.
If there were any warings, the test will give a "not ok" and diagnostics of
where, when and what the warning was, including a stack trace of what was
going on when the it occurred.
If some of your tests *are supposed to* produce warnings then you should be
capturing and checking them with the Test::Warn manpage, that way the
Test::NoWarnings manpage will not see them and so not complain.
The test is run by an 'END' block in Test::NoWarnings. It will not be run
when any forked children exit.